Dutch Tool Chest: Carcase Assemble

DTC_board_bevel  beveling the top of the back panel to match the sizes

DTC_front panel  attaching the front.  A little glud is used to keep the board in place.

DTC_helper

DTC_front panelThe front and backs are attached to the sides mostly with screws to allow seasonal movements

DTC_back_panels beading 2 DTC_back_panels beading 1 beading the tongued back panels

DTC_back_panels 1Using a pair of nickels to set the spacing between the tongue and groove panels.  They are also known as ‘test nickels’

DTC_back_panels 2 Assembling the panels.

no sanding neededPrepping the fall front panel.

Next up.  Fitting the fall front.

Leave a Reply

Your email address will not be published. Required fields are marked *